AUDIOQUEST SUB-A

Cavo RCA per Subwoofers Attivi

I Bassi sono il fondamento di tutta la musica. Il Subwoofer è in grado di riprodurre le armoniche con un effetto profondo non solo sul basso, ma su strumenti che non penseremmo mai potessero aver bisogno di un rinforzo sui bassi, come la voce femminile ed i violini. La prossima volta che avete la possibilità di ascoltare una voce femminile solista, provate a sentire la differenza una volta con il subwoofer e una volta senza. Ascoltate ciò che accade. Il cavo Sub-A è stato progettato per non permettere distorsioni del segnale in modo che i bassi vengano trasmessi con toni chiari e armoniche precise.

Caratteristiche Tecniche:

SOLID LONG-GRAIN COPPER CONDUCTORS (LGC): Solid conductors eliminate strand-interaction distortion. Sub-A's solid Long-Grain Copper allows a smoother and clearer sound than cables using regular OFHC (Oxygen-Free High-Conductivity) copper. OFHC is a general metal industry specification regarding “loss” without any concern for distortion. LGC has fewer oxides within the conducting material, less impurities, less grain boundaries, and definitively better performance.

SYMMETRICAL CONDUCTORS: Sub-A has identical conductors for the positive and ground connections. Underneath the 100% coverage foil shield is a bare conductor, exactly the same as the insulated center conductor. The conductor under the shield does double duty as a low distortion audio connection, and as the drain wire connecting the shield to ground.

TERMINATIONS: Precision gold-plated plugs are carefully attached with the very best solder. Through choice of flux and metallurgy, AQ solder has been optimized to make a low-distortion connection. All solder, including "silver solder," is a lousy conductor. The difference you hear between solders is a result of connection quality. AQ solder does not have a high silver content because the more silver there is in solder, the more difficult it is to make a good connection.

GROUNDING: Sometimes there is a hum problem unless the subwoofer and AV receiver (or surround-sound processor) are attached to each other using a separate wire. If your system has a hum problem, try attaching the little spade-lug tails to the metal chassis of the subwoofer amplifier and to the chassis of the sending component. Usually, this extra wire will not be needed.